ADS3day-88 This chapter shows how to use the Transient simulator to measure the mixer in the time domain. Lab 8: Transient Simulation Lab 8: Mixer Transient Simulations OBJECTIVES Simulate the mixer using Nyquist rules Manipulate various data traces and plots in the data display Compare the time domain results to harmonic balance PROCEDURE 1. In the Schematic window, open the previous mixer design from lab 6 (hb_gain) and save it with a new name: trans_mixer 2. Modify the circuit to look like the one shown here (described in the following steps if you need them): 8-2 Lab 8: Transient Simulations a. Disconnect the RF P_1Tone source and deactivate it. b. Insert a V_1Tone source for the RF and a 50 ohm series resistor as shown above. This voltage source is only being used here to practic……