TQM763022_LoadPullLoad Pull Contour Data for TQM763022 4x4 CDMA PA Module This document contains Load Pull Data for the TQM763022 in graphical form. Detailed descriptions of the data and how to interpret it are presented with each of the plots. All the data is referenced to the output pin of the PA module. To use the data with measurements on a handset board design, it is best to remove the PA module and install a semi-rigid cable probe to the phone board. Solder the outer sleeve of the probe to the ground paddle of the PA footprint and connect the center conductor to the output pin pad for the PA module as illustrated in the figure below. Using a network analyzer, perform a normal calibration on the network analyzer at the cable that will connect to the probe and the antenna output connector on the board t……