The PIC24HJ12GP201/202 (Rev. A2/A3) devices you
received were found to conform to the specifications
and functionality described in the following documents:
•“PIC24HJ12GP201/202 Data Sheet” (DS70282)
•“dsPIC30F/33F Programmer’s
Reference Manual” (DS70157)
The exceptions to the specifications in the documents
listed above are described in this section. The specific
devices for which these exceptions are described are
listed below:
• PIC24HJ12GP201
• PIC24HJ12GP202
PIC24HJ12GP201/202 Rev. A2/A3 silicon is identified
by performing a “Reset and Connect” operation to the
device using MPLAB
®
ICD 2 or MPLAB REAL ICE™
in-circuit emulator, with MPLAB IDE v7.60 or later. The
output window will show a successful connection to the
device specified in Configure>Select Device. The
resulting DEVREV register values for Rev. A2/A3
silicon is 0x3001 and 0x3002, respectively.
The errata described in this document will be
addressed in future revisions of silicon. PIC24HJ12GP201/202
PIC24HJ12GP201/202 Rev. A2/A3 Silicon Errata
The PIC24HJ12GP201/202 (Rev. A2/A3) devices you 5. UART
received were found to conform to the specifications The auto-baud feature measures baud rate
and functionality described in the following documents: inaccurately for certain baud rate and clock speed
“PIC24HJ12GP201/202 Data Sheet” (DS70282) combinations.
“dsPIC30F/33F Programmer’s 6. Traps and Idle Mode
Reference Manual” (DS70157)
If a clock failure occurs when the device is in Idle
The exceptions to the specifications in the documents mode, th……
