The active filter design tool (hereafter called the “tool”) is intended to accelerate a designer’s progress towards a working filter implementation by assisting in the op amp selection and component value solutions. The tool is intended to support LowPass (LP), HighPass (HP),and Bandpass (BP) filter requirements – as of this revision (1), the LowPass is implemented with HP and BP intended for addition to the tool in 2010. Application Note 1548 (Revision 1) Authors: Michael Steffes, Jian Wang, Oscar Mansilla Designer’s Manual for the iSim Active Filter Designer Design Tool Overview 1st Order Stages The active filter design tool (hereafter called the “tool”) Buffered single pole for non-inverting signal path (this is intended to accelerate a designer’s progress towards is an RC pole followed by a non-inverting gain stage). a working filter implementation by assisting in the op Active single pole for the inverting signal path (this is an RC amp selection and component value soluti……